In order to ensure the safety of the personnel, equipment and company materials of the operating personnel, to standardize the operating procedures, improve the operating efficiency, and reduce the operating costs of the equipment, we must formulate detailed procedures to avoid safety accidents and losses.

Follow the general safety electricity standard of the equipment, and the equipment must be connected to the ground wire.

Operation personnel must first receive special training organized by the company or workshop, understand the safety performance and precautions of the equipment, and read the "Safety Operation Rules" of the equipment. Only after passing the assessment, the operation is allowed.

The operator of the glue applicator must buckle up the buttons of the clothes and tighten the cuffs. If they have long hair, they must tie up their hair and tie them up. Do not wear gauze gloves when applying glue.

Before starting the machine, you need to check whether the power line of the device is safe. If the wire is broken and exposed, immediately report it to the maintenance before powering on. The emergency stop wire pulling device of the glue machine must be kept in good condition.

Operate the lifting equipment, pay attention to the maximum height that the control equipment can rise. Before leaving work, you need to restore the lifting platform to a position consistent with the ground height.

When gluing the woven fabric, the rubber roller must be lifted first, and then the non-woven fabric is fixed together with the sheet or plywood and then passed through the gluing machine. It is not allowed to directly pass the non-woven fabric through the operation without auxiliary items. Glue machine.

Do not write scribbles on the device, do not temporarily place any items such as pens, rulers, blades, roller brushes, etc. on the device, do not allow holes or weld items on the device, fix iron nails on the device, or allow Use hand or other tools to directly grab debris or get glue on the running rubber roller. To clear the debris on the rubber roller, it must be stopped.

Before the shift, the equipment must be cleaned up, and no glue should remain in the key parts of the equipment. Be sure to stop the operation after cleaning the glue. To clean the rubber roller, use a cotton cloth. Do not use strong corrosives to clean the rubber roller.

Industrial glue sometimes has a slight irritating odor, and it must be kept in a well-ventilated place.

The start-up of the glue machine should follow the following sequence: check the power lines and other hardware of the equipment-adjust the distance between the two rubber rollers-install the rubber stopper-pour the glue-connect the power

During the operation of the glue machine, glue is indispensable on the rubber roller. When the estimated downtime is more than 30 minutes, the remaining glue in the glue machine needs to be cleaned and removed in time.

When there is a thin sheet wound on the rubber roller and needs to be removed, it should be stopped first and then cut with a blade. When cutting, pay attention to the edge of the knife with the back of the knife pointing at the rubber roller to avoid cutting the rubber roller.